Exercise 1.1: Basic Transmission Pulses

From LNTwww


Considered basic transmission pulses

In this exercise, we examine the two transmitted signals  $s_{\rm R}(t)$  and  $s_{\rm C}(t)$  with square-wave and  $\cos^2$ basic transmission pulse, respectively, shown in the diagram. In particular, the following characteristics are to be calculated for the respective pulses  $g_s(t)$: 

  • the equivalent pulse duration of  $g_s(t)$:
$$\Delta t_{\rm S} = \frac {\int ^{+\infty} _{-\infty} \hspace{0.15cm} g_s(t)\,{\rm d}t}{{\rm Max} \hspace{0.05cm}[g_s(t)]} \hspace{0.05cm},$$
  • the energy of the basic transmission pulse  $g_s(t)$:
$$E_g = \int^{+\infty} _{-\infty} g_s^2(t)\,{\rm d}t \hspace{0.05cm},$$
  • the power of the transmitted signal  $s(t)$:
$$P_{\rm S} = \lim_{T_{\rm M} \to \infty} \frac{1}{+T_{\rm M}} \cdot \int^{+T_{\rm M}/2} _{-T_{\rm M}/2} s^2(t)\,{\rm d}t \hspace{0.05cm}.$$


Always assume in your calculations that the two possible amplitude coefficients are equally likely and that the distance between adjacent symbols is  $T = 1 \ \rm µ s$.  This corresponds to a bit rate of  $R = 1 \ \rm Mbit/s$.

  • The (positive) maximum value of the transmitted signal is the same in both cases
$$s_0 = \sqrt{0.5\, {\rm W}} \hspace{0.05cm}.$$
  • Assuming that the transmitter is terminated with a  $50\ \rm Ω$  resistor, this corresponds to the following voltage value:
$$s_0 = \sqrt{0.5\, {\rm W}} \hspace{0.05cm}.$$




Notes:

  • Given is the following indefinite integral:
$$\int \cos^4(a x)\,{\rm d}x = \frac{3}{8} \cdot x + \frac{1}{4a} \cdot \sin(2 a x)+ \frac{1}{32a} \cdot \sin(4 a x)\hspace{0.05cm}.$$


Questions

1

Are $s_{\rm R}(t)$ and $s_{\rm C}(t)$ unipolar or bipolar signals?

$s_{\rm R}(t)$  is a bipolar signal and  $s_{\rm C}(t)$  is a unipolar signal.
$s_{\rm C}(t)$  is a bipolar signal and  $s_{\rm R}(t)$  is a unipolar signal.

2

What is the equivalent pulse duration  $\Delta t_{\rm S}$, normalized to the symbol duration  $T$?

$\text{for the signal}\ \ s_{\rm R}(t) \text{:} \ \ \Delta t_{\rm S}/T \ = \ $

$\text{for the signal}\ \ s_{\rm C}(t) \text{:} \ \ \Delta t_{\rm S}/T \ = \ $

3

What is the energy of the rectangular basic transmission pulse??

$E_g \ = \ $

$\ \cdot 10^{-6}\ \rm Ws$

4

What is the power of the rectangular transmitted signal  $s_{\rm R}(t)$?

$P_{\rm S} \ = \ $

$\ \rm W$

5

What is the energy of the  $\cos^2$ basic transmission pulse?

$E_g \ = \ $

$\ \cdot 10^{-6}\ \rm Ws$

6

What is the power of the transmitted signal  $s_{\rm C}(t)$?

$P_{\rm S} \ = \ $

$\ \rm W$


Solution

(1)  Solution 2 is correct:

  • In both cases, the transmitted signal can be represented in the following form:
$$s(t) = \sum_{(\nu)} a_\nu \cdot g_s ( t - \nu \cdot T)$$
  • For the signal $s_{\rm R}(t)$, the amplitude coefficients $a_ν$ are either $0$ or $1$. Thus, a unipolar signal is present.
  • In contrast, for the bipolar signal $s_{\rm R}(t)$, $a_ν ∈ \{–1, +1\}$ holds.


(2)  The signal $s_{\rm R}(t)$ is NRZ rectangular.

  • Accordingly, both the absolute pulse duration $T_{\rm S}$ and the equivalent pulse duration $\Delta t_{\rm S}$ are equal to the symbol duration $T$:
$$T_{\rm S} / T = 1\hspace{0.05cm},\hspace{0.3cm}\Delta t_{\rm S} / T \hspace{0.1cm}\underline{ = 1 }\hspace{0.05cm}.$$
  • The basic transmission pulse for the signal $s_{\rm C}(t)$ is:
$$g_s(t) = \left\{ \begin{array}{c} s_0 \cdot \cos^2(\pi \cdot \frac{t}{T}) \\ 0 \\ \end{array} \right.\quad \begin{array}{*{1}c} {\rm{f\ddot{u}r}} \\ \\ \end{array}\begin{array}{*{20}c} -T/2 \le t \le +T/2 \hspace{0.05cm}, \\ {\rm sonst} \hspace{0.05cm}. \\ \end{array}$$
  • From the diagram on the information section, we can see that the following values apply to the $\cos^2$ pulse:
$$T_{\rm S} / T = 1\hspace{0.05cm},\hspace{0.3cm}\Delta t_{\rm S} / T \hspace{0.1cm}\underline{ = 0.5} \hspace{0.05cm}.$$


(3)  For the energy of the rectangular pulse holds:

$$E_g = \int^{+\infty} _{-\infty} g_s^2(t)\,{\rm d}t = s_0^2 \cdot T = 0.5\, {\rm W} \cdot 1\, {\rm µ s} \hspace{0.1cm}\underline{= 0.5 \cdot 10^{-6}\, {\rm Ws}}\hspace{0.05cm}.$$


(4)  For a bipolar square wave signal, the following would apply:

$$s_{\rm R}^2(t)= s_0^2 = {\rm const.} \hspace{0.3cm}\Rightarrow \hspace{0.3cm} P_s = s_0^2 \cdot \lim_{T_{\rm M} \to \infty} \frac{1}{T_{\rm M}} \cdot \int ^{T_{\rm M}/2} _{-T_{\rm M}/2} \,{\rm d}t = s_0^2 \hspace{0.05cm}.$$
  • However, since the signal $s_{\rm R}(t)$ is unipolar here, in half the time $s_{\rm R}(t)= 0$. Thus, we get:
$$P_{\rm S} = {1}/{2} \cdot s_0^2 \hspace{0.1cm}\underline{= 0.25 \,{\rm W}} \hspace{0.05cm}.$$


(5)  For the energy of the $\cos^2$ pulse holds:

$$E_g = \int^{+\infty} _{-\infty} g_s^2(t)\,{\rm d}t = 2 \cdot s_0^2 \cdot \int^{T/2} _{0} \cos^4(\pi \cdot {t}/{T})\,{\rm d}t \hspace{0.05cm}.$$
  • Here, the formula derived in point (3) and the symmetry of $g_s(t)$ about time $t = 0$ are considered.
  • The integral is given in the task description, where $a = π/T$ is to be set:
$$E_g = 2 \cdot s_0^2 \cdot \left [ \frac{3}{8} \cdot t + \frac{T}{4\pi} \cdot \sin(2 \pi \frac{t}{T})+ \frac{T}{32\pi} \cdot \sin(4 \pi \frac{t}{T})\right ]_{0}^{T/2}\hspace{0.05cm}.$$
  • The lower bound $t = 0$ always yields the result $0$. With respect to the upper bound, only the first term yields a result different from $0$. Thus:
$$E_g = 2 \cdot s_0^2 \cdot \frac{3}{8} \cdot \frac{T}{2} = \frac{3}{8} \cdot 5 \cdot 10^{-7}\, {\rm Ws} \hspace{0.1cm}\underline{ = 0.1875 \cdot 10^{-6}\, {\rm Ws}}\hspace{0.05cm}.$$


(6)  The following relationship holds for the bipolar signal $s_{\rm C}(t)$:

$$P_{\rm S} = \frac{ E_g}{T} = \frac{ 1.875 \cdot 10^{-7}\, {\rm Ws}}{10^{-6}\, {\rm s}}\hspace{0.1cm}\underline{ = 0.1875 \,{\rm W}} \hspace{0.05cm}.$$