Aufgaben:Exercise 4.15: MSK Compared with BPSK and QPSK

• Return to book

Power-spectral densities:   BPSK, QPSK, MSK KORREKTUR

Compare the power-spectral densities (in the equivalent low-pass range) of

• Binary Phase Shift Keying  $\rm (BPSK)$,
• Quaternary Phase Shift Keying  $\rm (QPSK)$,
• Minimum Shift Keying  $\rm (MSK)$.

These are shown logarithmically in the graph, with frequency normalized to the reciprocal of the bit duration  $T_{\rm B}$ .

For both BPSK and QPSK, a rectangular fundamental pulse of height  $s_0$  and symbol duration  $T$  is assumed. Thus, for BPSK and QPSK (as well as 4-QAM and offset QPSK), the same applies:

$${\it \Phi}_{s}(f) = \frac{s_0^2 \cdot T}{4} \cdot \big [ {\rm si}^2 ( \pi T \cdot (f- f_{\rm T}) ) + {\rm si}^2 ( \pi T \cdot (f+ f_{\rm T}) ) \big ]\hspace{0.05cm},$$

and transformed into the equivalent low-pass range:

$$ {\it \Phi}_{s,\hspace{0.05cm} {\rm TP}}(f) = \frac{s_0^2 \cdot T}{2} \cdot {\rm si}^2 ( \pi f T ) \hspace{0.05cm}.$$

Despite having the same formula, BPSK and QPSK have different power-spectral densities:

• In BPSK  (grey curve)  the symbol duration  $T$  is equal to the bit duration  $T_{\rm B}$  with an energy per bit of  $(E_{\rm B} = s_0^2 · T_{\rm B}/2)$ , it holds that:

$${\it \Phi}_{s,\hspace{0.05cm} {\rm TP}}(f) = E_{\rm B} \cdot {\rm si}^2 ( \pi f T_{\rm B} ) \hspace{0.05cm}.$$

• In contrast, in QPSK (blue curve) for the same  $E_{\rm B}$ , the symbol duration  $T$  is doubled:

$${\it \Phi}_{s,\hspace{0.05cm} {\rm TP}}(f) = 2 \cdot E_{\rm B} \cdot {\rm si}^2 ( 2\pi f T_{\rm B} ) \hspace{0.05cm}.$$

When calculating the MSK spectrum (red curve), one can take into account that MSK can be realized as an offset QPSK as in the block diagram  in the theory section if the following fundamental pulse is used:

$$g(t) = \left\{ \begin{array}{l} g_0 \cdot \cos (\pi/2 \cdot t/T) \\ 0 \\ \end{array} \right.\quad \begin{array}{*{5}c}{\rm{for}} \\{\rm{otherwise}} \\ \end{array}\begin{array}{*{10}c} -T \le t \le +T \hspace{0.05cm}, \\ {\rm }\hspace{0.05cm}. \\ \end{array}$$

The corresponding spectral function is calculated in  Exercise 4.15Z :

$$G(f) = \frac {4}{\pi}\cdot g_0 \cdot T \cdot \frac{ {\rm cos} ( 2 \pi f T )}{1 - (4 f T)^2 }\hspace{0.05cm}.$$

Additionally, consider:

• The two signals  $s_{\rm I}(t)$  and  $s_{\rm Q}(t)$  are uncorrelated despite prior encoding.
• For MSK, contrary to QPSK, one should set  $T = T_{\rm B}$  as in BPSK.
• Also, the energy per bit in MSK is given as:   $E_{\rm B} = s_0^2 · T/2$.
• The magnitude of the low-pass signal  $|s_{\rm TP}(t)| = s_0$  is equal to the maximum value $g_0$  of the fundamental pulse  $g(t)$.

Hints:

• This exercise belongs to the chapter  Nonlinear Digital Modulation.
• Particular reference is made to the section  Realizing MSK as Offset–QPSK.

• The power-spectral density in the equivalent low-pass range of one branch – for example:  the in-phase component – is:

$${\it \Phi}_{s,\hspace{0.05cm} {\rm I},\hspace{0.05cm} {\rm TP}}(f) = \frac{1}{2 T} \cdot {\rm E} \left [ a_\nu ^2 \right ] \cdot |G(f)|^2 \hspace{0.05cm}.$$

Questions

1

At what frequency  $f_1$ does the BPSK power spectral density have its first null point?  The reference value is the bitrate  $1/T_{\rm B}$.

$f_1 \ = \ $ $\ \cdot 1/T_{\rm B}$

2

At what frequency  $f_1$  does the QPSK power-spectral density have its first null point?

$f_1 \ = \ $ $\ \cdot 1/T_{\rm B}$

3

What is the MSK power-spectral density in the equivalent low-pass range?  What PSD value  $($normalized to $E_{\rm B})$  occurs at  $f = 0$ ?

${\itΦ}_\text{s, TP}(f = 0) \ = \ $ $\ \cdot E_{\rm B}$

4

Regarding the asymptotic spectral behaviour, which statements are true?

	The first PSD zero comes earlier in MSK than in QPSK.
	The MSK power-spectral density decays faster than that in QPSK.
	For MSK, the integral over  ${\itΦ}_\text{s, TP}(f)$  (not logarithmized!)  is larger than in QPSK.

Solution

Solution

(1)  From the equation and graph it can be seen that in the case of  Binary Phase Shift Keying  $\rm (BPSK)$ , the first zero of the power-spectral densityis at   $f_1\hspace{0.15cm}\underline{ =1} \cdot 1/T_{\rm B}$ .

(2)  Due to the lower symbol rate $1/T$,i  Quaternary Phase Shift Keying  $\rm (QPSK)$  – as well as all related quarternary modulation methods – has a spectrum half as wide as in BPSK   ⇒   $f_1\hspace{0.15cm}\underline{ =0.5} \cdot 1/T_{\rm B}$.

(3)  The power-spectral density   $\rm (PSD)$  of the total signal in the equivalent low-pass range is given by:

$${\it \Phi}_{s,\hspace{0.05cm} {\rm TP}}(f) = {\it \Phi}_{s,\hspace{0.05cm} {\rm I},\hspace{0.05cm} {\rm TP}}(f) + {\it \Phi}_{s,\hspace{0.05cm} {\rm Q},\hspace{0.05cm} {\rm TP}}(f)= 2 \cdot {\it \Phi}_{s,\hspace{0.05cm} {\rm I},\hspace{0.05cm} {\rm TP}}(f) = {1}/{ T} \cdot |G(f)|^2\hspace{0.05cm}.$$

This takes into account, that

• the signals  $s_{\rm I}(t)$  and  $s_{\rm Q}(t)$  are uncorrelated sind, such that one can add the PSD components,
• and that the expected value is   $E[a_ν^2] = 1$ , due to the binary bipolar amplitude coefficients.

This gives:

$${\it \Phi}_{s,\hspace{0.05cm} {\rm TP}}(f)= \frac{1}{ T} \cdot \left ( \frac {4}{\pi} \right ) ^2 \cdot g_0^2 \cdot T^2 \cdot \frac{ {\rm cos}^2 ( 2 \pi f T )}{ \big [1 - (4 f T)^2 \big ] ^2} \hspace{0.05cm}.$$

With  $s_0 = g_0$,  $T = T_{\rm B}$  and  $E_{\rm B} = s_0^2 · T_{\rm B}/2$ , it further holds that:

$${\it \Phi}_{s,\hspace{0.05cm} {\rm TP}}(f)= \frac{32}{ \pi^2} \cdot E_{\rm B} \cdot \frac{ {\rm cos}^2 ( 2 \pi \cdot f \cdot T_{\rm B} )}{ \big [1 - (4 \cdot f \cdot T_{\rm B})^2 \big ] ^2}\hspace{0.3cm} \Rightarrow \hspace{0.3cm} {\it \Phi}_{s,\hspace{0.05cm} {\rm TP}}(f = 0 )= \frac{32}{ \pi^2} \cdot E_{\rm B} \hspace{0.15cm}\underline {\approx 3.243 \cdot E_{\rm B}} \hspace{0.05cm}.$$

(4)  Only Answer 2 is correct:

• It can already be seen from the graph that the first statement is false and the second is correct.

(𝐸B/𝑇B).

• Answer 3 is also incorrect. The integral over the power-spectral densities yields the power   $(E_{\rm B}/T_{\rm B})$.
• The signal waveforms of BPSK, QPSK and MSK make it clear that the power with a constant envelope   $(s_0)$  is the same for these three modulation methods.