Exercise 3.2: GSM Data Rates

Block diagram of GSM

In this task, the data transmission with GSM is considered. However, since this system was mainly specified for voice transmission, we usually use the duration $T_{\rm R} = 20 \ \rm ms$ of a voice frame as a temporal reference in the following calculations. The input data rate is $R_{1} = 9.6 \ \rm kbit/s$. The number of input bits in each $T_{\rm R}$ frame is $N_{1}$. All parameters labelled "???" in the graphic should be calculated in the task.

The first blocks you will see in the transmission chain shown:

the outer coder (block code including four tail bits) with $N_{2} = 244 \ \rm Bit$ per frame $(T_{\rm R} = 20 \ \ \ \rm ms)$ ⇒ Rate $R_{2}$ is to be determined,
the convolutional coder with the code rate $1/2$, and subsequent puncturing $($waiver of $N_{\rm P} \ \rm bit)$ ⇒ Rate $R_{3} = 22.8 \ \rm kbit/s$,
Interleaving and encryption, both rate-neutral At the output of this block the rate $R_4$ occurs.

The further signal processing is basically as follows:

Each $114$ (coded, scrambled, encrypted) data bits are combined together with $34$ control bits (for training sequence, tail bits, guard period) and a pause $($Duration: $8.25 \ \ \rm Bit)$ to a so called Normal \ Burst . The rate at the output is called $R_{5}$ .
Additionally, further bursts (Frequency Correction Burst, Synchronisation Burst, Dummy Burst, Access Bursts) are added for signalling. The rate after this block is $R_{6}$.
Finally the TDMA multiplexing equipment follows, so that the total gross data rate of the GSM is $R_{\rm ges} = R_{7}$ .

The total gross data rate $R_{\rm ges} = 270,833 \ \rm kbit/s$ (for eight users) is assumed to be known.

Notes:

The task belongs to the chapter Gemeinsamkeiten von GSM und UMTS.
The graphic above summarizes the present description and defines the data rates used.
All rates are given in "$ \rm kbit/s$".
$N_{1}, N_{2}, N_{3}$ and $N_{4}$ denote the respective number of bits at the corresponding points of the above block diagram within a time frame of duration $T_{\rm R} = 20 \ \rm ms$.
$N_{\rm ges} = 156.25$ is the number of bits after burst formation, related to the duration $T_{\rm Z}$ of a TDMA time slot. Of which $N_{\rm Info} = 114$ are information bits including channel coding.

Questionnaire

$N_{1} \ = \ $

$\ \ \rm Bit$

$R_{2} \ = \ $

$\ \ \rm kbit/s$

$N_{3}\hspace{0.01cm}' \ = \ $

$\ \ \rm Bit$

$N_{3} \ = \ $

$\ \ \rm Bit$

$R_{4} \ = \ $

$\ \ \rm kbit/s$

$T_{\rm Z} \ = \ $

$\ \ \rm µ s$

$R_{6} \ = \ $

$\ \ \rm kbit/s$

$R_{5} \ = \ $

$\ \ \rm kbit/s$

sample solution

{{{ML Kopf}

(1) The following applies $N_{1} = R_{1} \cdot T_{\rm R} = 9.6 {\ \rm kbit/s} \cdot 20 {\ \rm ms} \hspace{0.15cm} \underline{\ 192 \rm bit}$.

'(2) Analogous to the subtask (1) applies: $$R_2= \frac{N_2}{T_{\rm R}}} = \frac{244\,{\rm bit}}{20\,{\rm ms}}\hspace{0.15cm} \underline { = 12.2\,{\rm kbit/s}}\hspace{0.05cm}.$$ Please note: For a redundancy-free binary source (but only this one), there is no difference between "$\rm bit$" and "$\rm bit$".

(3) The convolutional encoder of rate $1/2$ alone would generate exactly $N_{3}\hspace{0.01cm}' from its $N_{2} = 244$ input bits. \hspace{0.15cm}\underline{= 488}$ generate output bits per frame.

(4) Contrary, $N_{3} follows from the specified data rate $R_{3} = 22.8 \ \rm kbit/s$ \hspace\underline $456.

This means that from $N_{3}' = 488 \ \ \rm Bit$ are removed by the dotting $N_{\rm P} = 32 \ \ \rm Bit$.

(5) Both the interleaving and the encryption are "data neutral" so to speak. Thus the following applies:

$$R_{4} = R_{3} \hspace{0.15cm}\underline{= 22.8 \ {\rm kbit/s}} '''(6)''' The bit duration is $T_{\rm B} = 1/R_{7} = 1/(0.270833 {\ \ \rm Mbit/s}) \approx 3.69 \ \rm µ s$. *A burst - consisting of $156.25 \ \ \rm Bit$ - is transmitted in each time slot of duration $T_{\rm Z}$. *This results in $T_{\rm Z} \hspace{0.15cm}\underline{= 576.9 \ \rm µ s}$. '''(7)''' GSM has eight time slots, with one time slot being periodically assigned to each user. *The gross data rate for each user is $R_{6} = R_{7}/8 \hspace{0.15cm}\underline{ \approx 33.854 \ \rm kbit/s}$. '''(8)''' Considering that for the ''Normal Burst'' the amount of user data (including channel coding) is $114/156.25$, the rate would be without consideration of the added signaling bits: :$$R_5 = \frac{n_{\rm ges} }{\rm Info} \cdot R_4 = \frac{156.25}{114} \cdot 22.8\,{\rm kbit/s}\hspace{0.15cm} \underline { = 31,250\,{\rm kbit/s}}\hspace{0.05cm}.$$ *The same result can be obtained if you consider that in GSM every 13th frame is reserved for ''Common Control'' (signalling info): :$$R_5 = \frac{12}{13} \cdot 33,854\,{\rm kbit/s} ={ 31,250\,{\rm kbit/s}}\hspace{0.05cm}.$$ *Consequently , the percentage of signaling bits is: $$\alpha_{\rm SB} = \frac{33.854 - 31.250}{33.854} { \approx 7.7\%}\hspace{0.05cm}.$$

Category:Exercises for Mobile Communications|^3.2 Similarities between GSM and UMTS ^]]