Difference between revisions of "Exercise 2.2Z: DSL Internet Connection"

From LNTwww
 
(13 intermediate revisions by 4 users not shown)
Line 1: Line 1:
 
   
 
   
−
{{quiz-Header|Buchseite=Beispiele von Nachrichtensystemen/xDSL–Systeme
+
{{quiz-Header|Buchseite=Examples_of_Communication_Systems/xDSL_Systems
 
}}
 
}}
  
−
[[File:P_ID1932__Bei_Z_2_2.png|right|frame|Standard-DSL-Konfiguration]]
+
[[File:EN_Bei_Z_2_2.png|right|frame|Standard DSL configuration]]
  
−
Die Grafik zeigt eine mögliche Konfiguration eines DSL–Internetanschlusses, oben die Teilnehmerseite und unten die Komponenten der Vermittlungsstelle, welche die Telefonsignale (analog oder ISDN) über die digitale Vermittlung (DIV) zum Telefonnetz weiterleitet und die Datensignale zum Internet.
+
The graphic shows a possible configuration of a DSL Internet connection,  
 +
*above the subscriber side and
 +
*below the components of the exchange,  
  
−
Die Komponenten auf der Kundenseite, nämlich
+
 
 +
which forwards the telephone signals (analog or ISDN) via the digital exchange (DIV) to the telephone network and the data signals to the Internet.
 +
 
 +
The components on the customer side, viz.
  
 
*Splitter,
 
*Splitter,
 
*NTBA,
 
*NTBA,
−
*DSL–Router/Modem
+
*DSL router/modem
  
  
−
stehen im Mittelpunkt der folgenden Fragen.
+
are the focus of the following questions.
  
  
Line 21: Line 26:
  
  
−
''Hinweis:''
+
Hints:
  
−
Die Aufgabe gehört zum Kapitel [[Beispiele_von_Nachrichtensystemen/xDSL–Systeme|xDSL–Systeme]]  
+
*This exercise belongs to the chapter  [[Examples_of_Communication_Systems/xDSL_Systems|"xDSL Systems"]]  
  
  
Line 31: Line 36:
  
  
−
===Fragebogen===
+
===Questions===
 
<quiz display=simple>
 
<quiz display=simple>
  
−
{ Welche Komponenten trennen Sprach– und Datensignal beim Teilnehmer?
+
{ Which components separate voice and data signal at the subscriber?
 
|type="[]"}
 
|type="[]"}
−
- DSL–Router/Modem,
+
- DSL router/modem,
 
- DSLAM,
 
- DSLAM,
−
+ Splitter.
+
+ splitter.
  
  
−
{ Welche Bedeutung und Aufgaben hat der NTBA?
+
{ What is the importance and task of the NTBA?
 
|type="[]"}
 
|type="[]"}
−
+ Der NTBA ist nur bei ISDN erforderlich.
+
+ The NTBA is only required for ISDN.
−
+ Umsetzung von $\rm U_{\rm KO}$ auf $\rm S_0$ (Zweidraht &nbsP; &rArr; &nbsp; Vierdraht).
+
+ Conversion of&nbsp; $\rm U_{\rm KO}$&nbsp; to&nbsp; $\rm S_0$&nbsp; (two-wire &nbsp; &rArr; &nbsp; four-wire).
−
+ ISDN–Codeumsetzung von MMS43 auf den AMI–Code.
+
+ ISDN code conversion from "MMS43" to AMI code.
  
−
{ Welche Aufgaben hat das DSL–Modem bzw. der DSL–Router?
+
{ What are the tasks of the DSL modem or router?
 
|type="[]"}
 
|type="[]"}
−
+ Diese Einheiten bewerkstelligen eine Protokollumsetzung.
+
+ These units accomplish a protocol conversion.
−
+ Diese Einheiten beinhalten den Einschub „xTU–R”.
+
+ These units contain the "xTU-R" plug-in module.
−
- Diese Einheiten beinhalten den Einschub „xTU–C”.
+
- These units contain the "xTU-C" plug-in module.
  
  
Line 57: Line 62:
 
</quiz>
 
</quiz>
  
−
===Musterlösung===
+
===Solution===
 
{{ML-Kopf}}
 
{{ML-Kopf}}
−
'''(1)'''&nbsp; Richtig ist <u>der Lösungsvorschlag 3</u>. Der Splitter ist eine Kombination aus Hoch– und Tiefpass, der die Trennung des Telefonsignals (unterhalb von $120 \ \rm kHz$) vom DSL–Datensignal (oberhalb von $138 \ \rm kHz$) übernimmt bzw. deren Kombination.
+
'''(1)'''&nbsp; Correct is <u>the proposed solution 3</u>:
 +
*The splitter is a combination of a high-pass and low-pass filter that handles the separation of the telephone signal (below 120 kHz) from the DSL data signal (above 138 kHz), or their combination.
 +
 
  
−
'''(2)'''&nbsp; <u>Alle Aussagen</u> sind richtig. Genauere Informationen zum ISDN–Basisanschluss und insbesondere zum Netzabschluss (NTBA) finden Sie im Kapitel [[Beispiele_von_Nachrichtensystemen/ISDN-Basisanschluss|ISDN-Basisanschluss]] dieses Buches.
+
'''(2)'''&nbsp; <u>All statements</u> are correct.
 +
*For more detailed information on the ISDN basic access and especially on the network termination (NTBA), please refer to the chapter [[Examples_of_Communication_Systems/ISDN_Basic_Access|"ISDN Basic Access"]] of this book.
  
−
'''(3)'''&nbsp; Richtig sind <u>die beiden ersten Lösungsvorschläge</u>. Bei den heutigen DSL–Systemen dient stets ATM (''Asynchronous Transfer Mode'') als Basisprotokoll. Die Endgeräte der Kunden verwenden meist das Ethernet–Protokoll und können ATM–Zellen nicht verarbeiten. Die Protokollumsetzung geschieht anhand des Protokolls AAL5 (''ATM Adaption Layer Protocol 5'').
 
  
−
Die teilnehmerseitige xDSL–Einheit ist xTU–R ''(xDSL Transceive Unit – Remote)'' und befindet sich als Einschub im xDSL–Modem bzw. im Router. Dagegen ist das xTU–C ''(xDSL Transceive Unit – Central Office)'' im DSLAM (''Digital Subscriber Line Access Multiplexer'') in der Vermittlungsstelle oder im Kabelverzweiger untergebracht, also auf der Netzbetreiberseite.
+
'''(3)'''&nbsp; Correct are the <u>suggested solutions 1 and 2</u>:
 +
*DSL systems always use ATM (''Asynchronous Transfer Mode'') as the basic protocol.
 +
*The customers' terminal equipment, however, usually uses the Ethernet protocol and cannot process ATM cells.
 +
*The protocol conversion is based on the AAL5 protocol (''ATM Adaption Layer Protocol 5'').
 +
*The subscriber-side xDSL unit is $\rm xTU-R$ (''xDSL Transceive Unit - Remote'') and is located as a plug-in unit in the xDSL modem or router.  
 +
*In contrast, the $\rm xTU-C$ (''xDSL Transceive Unit - Central Office'') is located in the DSLAM (''Digital Subscriber Line Access Multiplexer'') in the exchange or in the cable distribution frame, i.e. on the network operator side.
  
 
{{ML-Fuß}}
 
{{ML-Fuß}}
Line 71: Line 83:
  
  
−
[[Category:Aufgaben zu Beispiele von Nachrichtensystemen|^2.2 xDSL–Systeme
+
[[Category:Examples of Communication Systems: Exercises|^2.2 xDSL Systems
 
^]]
 
^]]

Latest revision as of 19:28, 25 March 2023

Standard DSL configuration

The graphic shows a possible configuration of a DSL Internet connection,

  • above the subscriber side and
  • below the components of the exchange,


which forwards the telephone signals (analog or ISDN) via the digital exchange (DIV) to the telephone network and the data signals to the Internet.

The components on the customer side, viz.

  • Splitter,
  • NTBA,
  • DSL router/modem


are the focus of the following questions.




Hints:




Questions

1

Which components separate voice and data signal at the subscriber?

DSL router/modem,
DSLAM,
splitter.

2

What is the importance and task of the NTBA?

The NTBA is only required for ISDN.
Conversion of  $\rm U_{\rm KO}$  to  $\rm S_0$  (two-wire   ⇒   four-wire).
ISDN code conversion from "MMS43" to AMI code.

3

What are the tasks of the DSL modem or router?

These units accomplish a protocol conversion.
These units contain the "xTU-R" plug-in module.
These units contain the "xTU-C" plug-in module.


Solution

Solution

(1)  Correct is the proposed solution 3:

  • The splitter is a combination of a high-pass and low-pass filter that handles the separation of the telephone signal (below 120 kHz) from the DSL data signal (above 138 kHz), or their combination.


(2)  All statements are correct.

  • For more detailed information on the ISDN basic access and especially on the network termination (NTBA), please refer to the chapter "ISDN Basic Access" of this book.


(3)  Correct are the suggested solutions 1 and 2:

  • DSL systems always use ATM (Asynchronous Transfer Mode) as the basic protocol.
  • The customers' terminal equipment, however, usually uses the Ethernet protocol and cannot process ATM cells.
  • The protocol conversion is based on the AAL5 protocol (ATM Adaption Layer Protocol 5).
  • The subscriber-side xDSL unit is $\rm xTU-R$ (xDSL Transceive Unit - Remote) and is located as a plug-in unit in the xDSL modem or router.
  • In contrast, the $\rm xTU-C$ (xDSL Transceive Unit - Central Office) is located in the DSLAM (Digital Subscriber Line Access Multiplexer) in the exchange or in the cable distribution frame, i.e. on the network operator side.

Retrieved from "http://en.lntwww.de/index.php?title=Exercise_2.2Z:_DSL_Internet_Connection&oldid=53702"
  • Powered by MediaWiki